Starter Relay Switch Operation Inspection; Starter Relay Switch Circuit Inspection; Ground Line; Power Input Line - Honda MUV700 big red Service Manual

ELECTRIC STARTER
Install the hose guide and mounting bolts, then
tighten the bolts securely.
Install the starter motor cable and terminal nut, and
tighten the nut.
Install the rubber cap over the cable terminal.
Install the passenger seat under caver (page 3·6).
STARTER RELAY SWITCH
OPERATION INSPECTION
23-12
Remove the battery box cover (page 21-6).
Shift the sub-transmission into Neutral (set the gear
selector lever in the center position).
Turn the ignition switch to STAAT (il).
The coli is normal if the starter relay switch clicks.
If you don't hear the switch click, inspect the relay
switch circuits (page 23-12).
CIRCUIT INSPECTION
Remove the battery box cover (page 2'-6).
Disconnect the starter relay switch 2P green connec-
tor.
GROUND LINE
Check for continuity between the light green/black
wire terminal of the wire harness side con nector
and ground.
If there is continuity when the sub-transmission is in
Neutral, or when the brake pedal is depressed with
the ignition switch turned t o ON (I), the ground cir-
cuit is normal.
POWER INPUT LINE
Measure the voltage between the Yellow/red wire
terminal (+1 of the wire harness side connector and
ground (-).
If the battery voltage appears only when the ignition
switch is turned to START (II), Ihe power input cir-
cuil is normal.
TERMINAL NUT MOTOR CABLE