Lucent Technologies MERLIN LEGEND Release 7.0 Feature Reference page 467

MERLIN LEGEND Communications System Release 7.0
Feature Reference 555-670-110
Features
HotLine
Forward and
Follow Me
(continued)
Group Calling
Hold
Last Number Dial
Night Service
Paging
Park
Pickup
Pools
Privacy
Recall/Timed Flash
Ringing Options
Saved Number Dial
Speed Dial
Transfer
UDP Features
To remove Forward/Follow Me and Remote Call Forwarding at a Hotline
extension, you must use a telephone at a non-HotLine extension and
follow these steps:
1. Remove the Hotline feature from the extension.
2. Cancel Forward/Follow Me or Remote Call Forwarding.
3. Reassign the Hotline feature to the extension.
From HotLine extension, you can dial a calling group extension number.
Hold is not available at HotLine extensions.
Last Number Dial is not available at HotLine extensions.
A HotLine extension (Release 5.0 and later systems) can be a member of
a Night Service group. If you dial an outside call from a Hotline extension
and Night Service with Outward Restriction is on, either the HotLine
extension number must be in the Night Service Exclusion List or the
number it dials must be on the Night Service Emergency List.
You cannot access Loudspeaker Paging from a HotLine extension, but a
HotLine extension can be programmed to dial a Group Paging number.
Park cannot be used by a HotLine extension.
Pickup cannot be used at a HotLine extension.
A HotLine extension can use a pool, as long as dial-access-to-pools is
enabled for the extension and the Pool access code is programmed with
the outside number as the first Personal Speed Dial number for the
extension.
Privacy is not available for HotLine extensions.
A switchhook flash from a HotLine extension is not sent to the system or
the central office.
Ringing Options can be set for HotLine extension lines. If the HotLine
extension should not receive calls, set its line for No Ring.
Saved Number Dial is not available at HotLine extensions.
A HotLine extension can dial only the first Personal Speed Dial number
(code 01) programmed for the extension. The end-of-dialing digit, #,
should be programmed at the end of the speed dial number. See
Appendix H, ''Programming Special
information.
Transfer is not available at HotLine extensions.
In Release 6.0 and later systems (Hybrid/PBX mode only), a HotLine
extension must be on the local system. However, a HotLine telephone
can dial a non-local extension.
Characters," for additional
Issue 1
April 1999
407