MERLIN LEGEND Communications System Release 7.0
Feature Reference 555-670-110
Features
Pickup
To answer calls on specific lines, press a programmed general-purpose Pickup
button, or press the Feature button and dial 9; then dial the number of the line with
the call.
If a Pickup button is programmed for a specific telephone or outside line, press
that Pickup button to pick up a call.
Group Pickup
To pick up a call ringing on any other group member's telephone, press a
programmed Group Pickup button, or press the Feature button and dial 88. MLX
telephone users also can press the Feature button and select the feature from the
display.
MLC-5 cordless telephones cannot be assigned to Pickup groups.
Single-Line Telephones
Individual Pickup
To pick up a parked call, lift the handset and (while listening to the inside dial tone)
dial #9 and the extension number for the telephone or park zone.
Group Pickup
To pick up a call ringing at any other group member's telephone, lift the handset
and (while listening to the inside dial tone) dial #88.
NOTE:
When on a single-line telephone, if you put a call on hold to pick up another
call by using Individual or Group Pickup, you cannot put the picked-up call
on hold to return to the first call. If you press the Recall or Flash button (or,
on a telephone that does not have timed or positive disconnect, if you press
and release the switchhook), the picked-up call is dropped and you are
reconnected to the original held call. If you hang up, the picked-up call is
disconnected and the first call is considered on hold for transfer, is returned
to you after the transfer return interval.
Feature Interactions
Callback
Call Waiting
Conference
A callback request cannot be picked up at another telephone.
Pickup cannot be used to answer a waiting call at another extension.
A conference call cannot be picked up at another extension. A conference
originator can, however, pick up a call and add it to the conference call.
Issue 1
April 1999
497
Need help?
Do you have a question about the MERLIN LEGEND Release 7.0 and is the answer not in the manual?