Lucent Technologies MERLIN LEGEND Release 7.0 Feature Reference page 375

MERLIN LEGEND Communications System Release 7.0
Feature Reference 555-670-110
Features
Do Not Disturb
Multi-Function
Module
Paging
Reminder Service
Service Observing
Signal/Notify
System Access/
Intercom Buttons
Transfer
Voice Announce
Using Do Not Disturb is not recommended because the device connected
to the MFM does not have an LED to indicate when the feature is active.
Group pages cannot be made to a telephone with Do Not Disturb on.
Reminder calls ring at telephones with Do Not Disturb turned on.
In Release 6.1 and later systems a Service Observer can observe calls
even if the observed extension uses the Do Not Disturb feature.
Activating Do Not Disturb at a Service Observer extension does not block
the Service Observer from being alerted when a call comes into an
observed extension.
When an extension being observed activates Do Not Disturb, this causes
the green LED next to the observed extension's button on the Service
Observer's telephone or the red LED on the DSS to light.
Signaling cannot be used when the destination telephone user turns on
Do Not Disturb.
Do Not Disturb prevents ringing of incoming calls at SA or ICOM buttons
(including Shared SA buttons) on the telephone where the feature is
turned on. This also prevents calls received on the principal's SA buttons
from ringing at other telephones with Shared SA buttons for that
extension.
Calls transferred to telephones that have Do Not Disturb turned on are
returned after the transfer return interval expires, unless the telephone
has coverage and a receiver is available. In that case, the transferred call
is sent to the receiver.
A user with Do Not Disturb active does not receive voice-announced
calls.
Issue 1
April 1999
315