Lucent Technologies MERLIN LEGEND Release 7.0 Feature Reference page 622

MERLIN LEGEND Communications System Release 7.0
Feature Reference 555-670-110
Features
Programming
Line buttons (represented in the lower portion of the display).
To use SPM for system programming, you must connect the PC to the control unit.
This can be done either directly through the system programming jack on the
control unit or through a modem (modems can be used for either on-site or remote
programming). See System Programming for details on SPM use.
NOTE:
Beginning with Release 3.0, SPM is no longer necessary in order to back
up system progr888amming. System programming can be backed up on a
memory card. For details, see System Programming .
Figure 30.
Onsite and Remote Programming
PC-based SPM programming through a modem is performed either onsite or from
a remote location. In both cases, the modem built into the control unit is used.
Dialing *10 connects to the control unit modem's extension jack.
The built-in modem for remote programming can be reached in any of the
following ways:
Call the system on a remote-access line and enter a barrier code (if
needed), and then dial the code for the control unit's built-in modem (*10).
Call the system on a regular line and ask the system operator to transfer
the call to the control unit's built-in modem (*10).
SPM Display
Issue 1
April 1999
562