Lucent Technologies MERLIN LEGEND Release 7.0 Feature Reference page 887

MERLIN LEGEND Communications System Release 7.0
Feature Reference 555-670-110
General Feature Use and Telephone Programming
Telephone Programming
Table D-4. Programming Analog Multiline Telephones
Step
1 Label the button.
NOTE:
Skip this step if the feature
is not programmed on a
button.
2 Begin programming.
3 Select the feature or setting.
4 End programming.
Action
Remove the clear label cover from the telephone:
insert the end of a paper clip in the notch at the top
of the cover.
Write the feature name on the card next to the
button to be programmed.
Replace the cover.
Slide the T/P switch on the side of the telephone to
P.
Press the button you labeled.
If you have a display telephone, it shows the name
of the feature currently programmed on the button.
If no feature is programmed, the display indicates
that the button is blank.
NOTE:
If the feature does not get programmed onto
a button, press any line button. This does not
affect the button in any way.
Dial the programming code.
The feature is programmed.
Slide the T/P switch to the center position.
Issue 1
April 1999
D-29