Lucent Technologies MERLIN LEGEND Release 7.0 Feature Reference page 710

MERLIN LEGEND Communications System Release 7.0
Feature Reference 555-670-110
Features
Speed Dial
area codes. In Hybrid/PBX mode, a Personal Speed Dial number also can include
pool dial-out codes or the ARS code. When dial-out codes are included, Pause
characters may be required immediately following the dial-out code to allow time
to receive the telephone company dial tone.
The Personal Speed Dial codes used to select specific programmed numbers are
01 to 24. Because each user has the same codes from which to choose, the
telephone numbers for the codes apply only to the extension for which they were
programmed.
NOTE:
This feature should be used with BIS-10, MLC-5, MDW 9000, MDC 9000,
MLX-5, MLX-5D, MLX-10, MLX-10DP, MLX-16DP, MLX-10D, ETR-6, and
MLS-6 telephones only . MLX-20L telephone users should program a
Personal Directory instead of Personal Speed Dial codes. MLX-28D, ETR-
18/18D, ETR-34D, MLS-12/12D, MLS-18/18D, and MLS-34D telephone
users and users of analog multiline telephones with more than ten buttons
should program Auto Dial buttons instead of Personal Speed Dial codes.
Programming Personal Speed Dial codes on telephones with more than ten
buttons may delete features already programmed onto those buttons.
Considerations and Constraints
Personal Speed Dial numbers can be used only with single-line telephones, digital
data devices, modem data-only workstations, and multiline telephones with 16 or
fewer buttons.
In Release 1.1 later systems, when you are programming Personal Speed Dial on
MLX-5D, MLX-10D, MLX-10DP, or MLX-16DP telephones, select
display after dialing the telephone number. Otherwise, the number is not
programmed.
A number dialed by using a marked System Speed Dial code overrides any calling
restrictions (such as toll or outward restrictions) assigned to the extension.
The following special characters can be used in numbers programmed for Speed
Dial codes: Pause (Hold), Stop (Drop), Flash (Conf), and End of Dialing (#). See
Appendix
When a pool dial-out or ARS code is included in the dialing sequence associated
with a Personal Speed Dial or System Speed Dial code, pauses may be required
immediately after the dial-out code to allow time to receive outside dial tone.
Personal and System Speed Dial cannot be used at rotary dial telephones.
H, ''Programming Special Characters," for additional information.
Issue 1
April 1999
650
from the
Enter