Recall/Timed Flash - Lucent Technologies MERLIN LEGEND Release 7.0 Feature Reference

MERLIN LEGEND Communications System Release 7.0
Feature Reference 555-670-110
Features

Recall/Timed Flash

Recall/Timed Flash
At a Glance
Users Affected
Reports Affected
Modes
Telephones
Programming Codes
Recall
Conference
Drop
Transfer
Feature Code
MLX Display Label
System Programming
Factory Setting
Recall Timer
Description
Recall sends a momentary signal called a timed flash or switchhook flash while
the telephone is on the hook. A timed flash is used as a control signal, as follows:
On an inside call, the signal is intercepted by the control unit.
On an outside call, when the system is using host switch services such as
Centrex, the signal may be sent to the host, depending on the type of
telephone and system operating mode.
Telephone users, DLC operators
Extension Information, System Information (SysSet-up)
All
All except QCC
*775
*772 (Behind Switch mode only)
*773 (Behind Switch mode only)
*774 (Behind Switch mode only)
775
Recall [Recll]
Change timed-flash duration (recall timer):
Options
Program fixed Conference, Drop, and Transfer buttons to
access host features in Behind Switch mode:
Options
Drop/Transfer
450 ms (options 350 ms, 450 ms, 650 ms, 1 sec)
— A multiline telephone user can use Recall to disconnect a call and
get a new dial tone without hanging up. The user can be on an
active call or listening to ringback or dial tone. When the user is
listening to a busy signal, Recall has no effect.
— A single-line telephone user can use Recall to put an active call on
hold and to access system features such as Conference and
Transfer.
More
RecallTimer
More
BehndSwitch
Issue 1
April 1999
590
Conference/