Lucent Technologies MERLIN LEGEND Release 7.0 Feature Reference page 450

MERLIN LEGEND Communications System Release 7.0
Feature Reference 555-670-110
Features
Headset Options
Two conditions are necessary for an MLX telephone user or MLX DLC operator to
use the Headset Status feature:
A Headset Hang Up button must be programmed, as described in the
previous section.
A Headset Status button must be programmed on the telephone or
console, through either extension programming or centralized telephone
programming.
A Headset Status button is a fixed feature on a QCC and cannot be deleted or
changed.
To use Headset Auto Answer, Headset/Handset Mute, or Headset Hang Up on a
telephone or console with a Headset Status button, Headset Status must be on.
When Headset Status is on, switchhook operation is disabled. The handset or
speakerphone can be used to make or answer a call, but the only way for the user
or operator to disconnect from a call is by pressing the Headset Hang Up button.
The user or operator can turn off the headset and switch back to switchhook
operation by pressing the Headset Status button; the green LED next to the
button turns off.
Headset Auto Answer
A Headset Auto Answer button allows an MLX telephone user or operator with a
headset to be connected automatically to a ringing call. Headset Status must be
on, as described in the two previous sections, before Headset Auto Answer can
be used.
When Headset Auto Answer is turned on, the green LED next to Headset Auto
Answer button is on, and the user or operator hears a zip tone through the
headset to indicate an incoming call. Following the tone is a brief pause, during
which the microphone is temporarily disabled to prevent the user's or operator's
private conversation from being heard by the caller.
When Headset Auto Answer is on and the user presses the Headset Auto Answer
button with a ringing call (for example, when Ringing/Idle Line Preference is
turned off), the call is answered without the user hearing zip tone.
Headset Auto Answer can be turned on and off during a call without disconnecting
the caller. The turning on or off takes effect immediately.
Headset Auto Answer does not automatically answer voice-announced calls.
When the user or operator is on a call, Headset Auto Answer is turned off; calls
are not answered automatically until the caller hangs up or the user or operator
presses the Headset Hang Up button to disconnect the call.
Issue 1
April 1999
390