Park - Lucent Technologies MERLIN LEGEND Release 7.0 Feature Reference

MERLIN LEGEND Communications System Release 7.0
Feature Reference 555-670-110
Features

Park

Park
At a Glance
Users Affected
Reports Affected
Modes
Telephones
Programming Codes
Park at own extension
Park Zone
MLX Display Label
Park at own extension
Park Zone
System Programming
Maximums
No. of parked calls in park
zones
Factory Settings
Park Zones
Call Park Return Interval
QCC Priority Level for
returning parked calls
Description
Park puts a call on hold so that it can be picked up from any extension in the
system. A user can park a call and then pick it up at another telephone, or can use
paging to announce the call so that another person can pick it up. A parked call is
picked up using the Pickup feature.
A user (but not a QCC operator) can park calls at his or her own extension by
activating Park during the call, or by pressing the Transfer button, dialing his or
her own extension number, and pressing the Transfer button again to complete
the transfer. The green LED winks at the button where the call is parked and at all
other associated SA and Shared SA buttons. At least two SA or ICOM buttons are
required to use Park this way, and if you must park more than one call at a time,
additional SA or ICOM buttons should be assigned to your telephone.
Telephone users, operators
Extension Information, Operator Information, System
Information (SysSet-up)
All
All except single-line
*86
*22 + park zone (DLC operators only)
Park
Park Zone [PrkZn]
Assign return interval before unanswered parked call returns:
Options CallParkRtn
8 (one parked call for each zone)
Ext. 881–888
180 sec (range 30–300 sec, in increments of 10 sec)
4 (range 1–7)
Issue 1
April 1999
479