Camp-On - Lucent Technologies MERLIN LEGEND Release 7.0 Feature Reference

MERLIN LEGEND Communications System Release 7.0
Feature Reference 555-670-110
Features

Camp-On

Camp-On
At a Glance
Users Affected
Reports Affected
Modes
Telephones
Programming Code
Feature Codes
MLX Display Label
System Programming
Factory Setting
Return Interval
Description
Camp-On allows you to complete a transfer to a busy extension. The call is put on
hold until the extension can receive a call; then it rings automatically. While the
call is on hold, the caller (inside or outside) hears special ringback. A call waiting
tone sounds at the busy extension to indicate that a call is waiting. If you do not
answer the call within the programmed Camp-On return interval (30–300
seconds), the call returns to the originator. The originator hears a priority ring (one
ring and two beeps) to indicate a returning Camp-On call.
Camp-On can also be used to complete a transfer to an extension that is not busy.
This can increase the amount of time before the call returns to the originator,
because the return call is timed according to the Camp-On return interval (30–300
seconds) instead of the transfer return interval (1–9 rings). Camp-On can be
activated by using either a programmed button or a feature code.
Considerations and Constraints
A Camp-On return interval of 30 to 300 seconds in increments of 10 seconds can
be programmed. The factory setting is 90 seconds.
A call-waiting tone sounds a destination telephone when a call is camped-on,
even if Call Waiting is not programmed on the destination extension.
Telephone users, operators
System Information (SysSet-up)
All
All except single-line telephones and data equipment
*57
57
87 (Call Waiting Pickup)
Camp On [Camp] + caller's extension label
Change the amount of time before a camped-on call
returns to originator:
Options CampOn
90 seconds (range 30–300, in increments of 10 seconds)
Issue 1
April 1999
140