Lucent Technologies MERLIN LEGEND Release 7.0 Feature Reference page 655

MERLIN LEGEND Communications System Release 7.0
Feature Reference 555-670-110
Features
Recall/Timed Flash
Automatic Route
Selection
Barge-In
Basic Rate Interface
Callback
Call Waiting
Conference
Coverage
Directories
In Release 2.0 and later systems, Recall can be used on an ARS call.
Recall cannot be used during dialing. When dialing is complete, pressing
the Recall button sends a timed flash to the host, the accessed line is
kept, the user hears outside dial tone, and calling restrictions are
reapplied.
In Release 1.0 and 1.1 systems, Recall cannot be used on an ARS call
because the call is made on an SA button.
In Release 2.0 and later systems, Recall can be used by either party on a
call joined using Barge-In.
In Release 1.0 and 1.1 systems, Recall cannot be used with Barge-In.
Recall is not recognized by the central office on BRI lines. Thus, the
central office ignores a press of the Recall button.
If Recall is used while a user is off hook with a queued callback request,
the call is disconnected and the user hears dial tone.
If Recall is used while a user is hearing special ringback, the call is
disconnected and the user hears inside dial tone.
The Conf button is used to enter the Flash special character, which
simulates pressing the Recall button in telephone numbers programmed
for Directories, Auto Dial buttons, or Speed Dial codes.
In Hybrid/PBX and Key modes, a single-line telephone user with a Recall
or Flash button can add a participant to a conference call and connect all
participants by using the Recall or Flash button. In addition, the Recall or
Flash button can be used either to drop the most recently added
participant or to drop a busy number.
In Behind Switch mode, the fixed Conf button on an MLX, ETR, MLS, or
analog multiline telephone must be set through system programming to
send a timed flash plus the code expected by the host switch to activate
conference on the host. If the communications system's Conference
feature is also desired, it must be assigned to an available line button on
each multiline telephone through extension or centralized telephone
programming. Recall has no effect on a completed conference call.
Recall has no effect on a call answered on a Primary Cover, Secondary
Cover, or Group Cover button.
In Release 2.0 and later systems, Recall can be used on a Group
Coverage call answered by a member of a calling group. In Release 1.0
and 1.1 systems, Recall cannot be used on a call of this type because it is
answered on an SA or ICOM button.
The Conf button is used to enter the Flash special character, which
simulates pressing the Recall button in a Directory listing telephone
number.
Issue 1
April 1999
595