Enabling/Disabling Ftp Server; Configuring Source Ip Address For Ftp Serve And Client - 3Com 5500-SI Configuration Manual

444 C 22: F S
HAPTER ILE YSTEM
Enabling/Disabling FTP
Server
Configuring Source IP
Address for FTP Serve
and Client
M
ANAGEMENT
Table 484 Configuration of the Switch as FTP Client
Device Configuration
Default Description
Switch Log into the remote FTP server directly with the ftp command.
-- You need first get FTP user command and password, and then log into the
remote FTP server. Then you can get the directory and file authority.
PC Start FTP server and make such settings as username, password, authority.
-- --
Table 485 Configuration of the Switch as FTP Server
Device Configuration
Switch Start FTP server.
Configure authentication and
authorization for FTP server.
Configure running parameters for
FTP server.
PC Log into the Switch from FTP client.
The prerequisite for normal FTP function is that the Switch and PC are reachable.
You can use the following commands to enable/disable the FTP server on the Switch.
Perform the following configuration in System View.
Table 486 Enable/Disable FTP Server
Operation
Enable the FTP server
Disable the FTP server
FTP server supports multiple users to access at the same time. A remote FTP client
sends request to the FTP server. Then, the FTP server will carry out the corresponding
operation and return the result to the client.
By default, FTP server is disabled.
You can configure source IP address or source interface for the FTP server and FTP
client to enhance service manageability.
Table 487 shows the source IP address configuration tasks.
Table 487 Configure source IP address for FTP Server and Client
Operation
Enter system view
Specify source IP address for the FTP
server
Specify source interface for the FTP
server
Use a specified source IP address to
establish a connection with an FTP
server
Default
FTP server is
disabled.
-
-
-
Command
ftp server enable
undo ftp server
Command
system-view
ftp-server source-ip ip-addr
ftp-server source-interface
interface-type interface-number
ftp { cluster | remote-server } source-ip
ip-addr
Description
You can view the configuration
information of FTP server with
the ftp-server command.
Configure username, password
and authorized directory for
FTP users.
Configure timeout time value
for FTP server.
-
Remarks
-
Optional
Optional
Optional