Show Interface Transceiver - Cisco Nexus 5500 Series Command Reference Manual

Chapter Show Commands

show interface transceiver

To display the information about the transceivers connected to a specific interface, use the show
interface transceiver command.
Syntax Description ethernet
slot/[QSFP-module/]port
details
Command Default None
Command Modes EXEC mode
Command History Release
6.0(2)N1(1)
5.2(1)N1(1)
Usage Guidelines You can use the show interface transceiver command only for physical interfaces.
Examples
This example shows how to display the transceivers connected to a specified Ethernet interface:
switch# show interface ethernet 1/1 transceiver
Ethernet1/1
switch#
OL-27880-02
show interface ethernet slot/[QSFP-module/]port transceiver [details]
Displays information about an Ethernet interface slot number and port
number. The slot number is from 1 to 255. The QSFP-module number is
from 1 to 4. The port number is from 1 to 128.
Note
(Optional) Displays detailed information about the transceivers on an
interface.
Modification
Support for the QSFP+ GEM was added.
This command was introduced.
transceiver is present
type is SFP-H10GB-CU1M
name is CISCO-MOLEX
part number is 74752-9044
revision is 07
serial number is MOC14081360
nominal bitrate is 10300 MBit/sec
Link length supported for copper is 1 m
cisco id is --
cisco extended id number is 4
The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
show interface transceiver
1307