4.
Remove the new fuser unit from it's package, align it over the
printer, and lower the unit straight down into the printer.
Tighten the thumbscrews to secure the unit in place (fig. 9.28).
5.
Install a fuser oil bottle. See "Installing or Replacing the Fuser
Oil Bottle" in chapter 2.
Note: If you are going to use the oil bottle from the fuser unit
that you removed, make sure to transport the bottle
keeping a blank sheet of paper under it to prevent oil
drips from damaging your printer.
6.
Close the printer's top and front covers. If you are not cleaning
other areas, reconnect the power cord; then, turn on the printer.
Replacing the Toner Waste Pack
A front panel status message will alert you when the toner waste
pack needs to be replaced. This is usually after running
approximately 18,000 single-sided copies.
To replace the toner waste pack
1.
Open the front cover (9.29).
Toner Waste Pack
Fig. 9.29 Replace the Toner Waste Pack
_________________________
Maintenance and Specifications 9-25