Xante ScreenWriter Colour ScreenWriter User Manual page 337

Fig. 10.25 Ethernet Board Sockets and Post
5. Replace the current plastic post with the new one by
unscrewing the old post from the plastic nut on the back of the
controller board (fig. 10.26). Then, screw the new hexagonal
plastic post into the plastic nut on the back of the controller
board (fig. 10.26).
Plastic Nut
Fig. 10.26 Replace the Old Plastic Post with the New Post
6. Align the Ethernet board over it sockets and post (fig. 10.25).
Then, lower the it down onto the controller board making sure the
Ethernet board pins fit snugly into the controller board sockets.
7. Attach the metal back plate by inserting and tightening the hex
screws on either side of the serial port; then, insert and tighten the
Phillips head screws on either side of the parallel port (fig. 10.23).
___________________________________________
Ethernet Board Sockets
Post Opening
Plastic Screw
Hexagonal Plastic Post
Options 10-27