10/100BaseT Upgrade
You can upgrade the printer's standard 10BaseT unshielded twisted
pair configuration for the Ethernet port to a 10/100BaseT
configuration. After installing the Ethernet upgrade, see chapter 6 for
information about configuring and using the Ethernet options.
Required tools:
1.
Remove the controller board following the instructions earlier
in "Removing the Controller Board" in this chapter.
2.
Remove the old Ethernet board using the following procedure.
a.
Locate and remove the two hex screws attaching the
metal back plate on either side of the serial port (fig.
10.23).
Phillips Head Screw
Parallel Port
Phillips Head Screw
Hex Screw
Serial Port
Hex Screw
Fig. 10.23 Remove the Back Plate's Securing Screws
___________________________________________
• A small magnetized Phillips head screwdriver
• A 3/16" hex nut driver or needle nose pliers
Metal Back Plate
Options 10-25