Table of Contents
Advertisement
20.
Enable Novell Print Server on the printer's front panel using
the following procedure.
a.
Press the Online key once to take the printer offline.
b.
Press the Menu key until SETUP:I/F appears; then, press
the Enter key.
c.
Press the Menu key until I/F:NOVELL PRTSRV
appears; then press the Enter key. NOVELL
PSRV:ENABLE appears.
d.
Press the Enter key. Then, press the Menu key until
ENABLE:yes appears.
e.
Press the Enter key. Then press the Online key.
The Novell server is now configured for NetWare version 5.X.
Configure the Print Server Emulation
Following the file server setup, the Novell System Administrator
assigns the printer a list of file servers to poll and gives it the login
name and password (if required) to access each server. This section
describes how to configure the print server emulation using XANTÉ
Command Center. See your Novell NetWare documentation if you
prefer to use that application. See chapter 3 (Macintosh) or 4 (PC) to
install and configure Command Center on your host computer.
Using XANTÉ Command Center (PC)
Note: Your PC must be directly connected to the printer through a
bidirectional parallel or a serial cable to use XANTÉ
Command Center. You cannot set the commands through a
network connection.
1.
Open XANTÉ Command Center by double-clicking its icon.
_______________________________________ Ethernet Setup 5-15
Advertisement
Table of Contents
Troubleshooting
