Menu Structure - Xante ScreenWriter Colour ScreenWriter User Manual

To perform a level 2 reset, turn off the printer; next, press and hold
down the Online and Duplex keys while you turn on the printer. Release
the keys after RESET 2 appears in the window. The display will read
initializing and then go through the normal start-up sequence.

Menu Structure

Configuration menus allow you to configure many printer feature
defaults and the printer interfaces. The main configuration menu
groups are the Graphics, Interface (I/F), Media, Utility, and
Maintenance menus (fig. 6.2).
Use the Graphics menus to set options related to graphic attributes
such as lines per inch and the color mode. Use Interface menus to set
the printer's serial, parallel, LocalTalk, and Ethernet interface
defaults. Use the Media menu to select the media type. Use Utility
menus to set printer feature defaults and to print miscellaneous utility
pages. Use Maintenance menus to notify the printer that an engine
service condition has been cleared.
SETUP
SETUP
I/F
GRAPHICS
DHCP
COLOUR MODE
ETHERTALK
COLOUR OUTPUT
IP ADDRESS
COLOUR PROFILE
LINEPRINTER
DPI
LOCALTALK
LPI
NOVELL PRNTSRV
REGISTRATION
PARALLEL
SPOT FUNCTION
RS232
UCR
XACT*
* Calibrates all trays
_______________________________________
READY/IDLE
SETUP
SETUP
MEDIA UTILITY
MEDIA TYPE ACCELAFONT*
ENVELOPE JOB TIMEOUT
LANGUAGE
LASER POWER
POWER SAVE
RAM DISK
STARTUP PAGE
TRAY SWITCH
UTILITY PAGES
* Only with IDE drive
and RAM Disk enabled
Fig. 6.2 Main Menus
SETUP
MAINTENANCE
REPLACED ITEM
Configuration 6-7