Toner And Manual Feed Area Cleaning - Xante PlateMaker 3 Manual

4. Clean toner from the transfer roller with a soft bristle brush.
5. Vacuum the area using a soft brush attachment or blow it with
compressed air.
Warning! Wear protective safety glasses when using compressed
air.
Caution:
6. Lower the roller back into place with the gear end to the left.
Make sure the lever protruding below the transfer roller fits
inside the small opening on the door.
7. Push the roller into its holding clips. The roller assembly
should spring back freely when pressed.

Toner and Manual Feed Area Cleaning

Clean the toner and manual feed area after removing a paper jam or
replacing the toner cartridge.
1. Turn off the printer and disconnect it from the power source;
then remove the paper jam or the toner cartridge.
Caution:
9-8 Maintenance and
Do not pull out wires while performing this step.
The fuser becomes very hot during operation.
Always allow the fuser to cool completely before
opening the fuser cover. If a paper jam occurs in
the fuser area, turn off the printer and wait at least
30 minutes before attempting to clear the jam.
Specificationsbb ________________________