Replacing The Drum Cleaner - Xante ScreenWriter Colour ScreenWriter User Manual

Replacing the Drum Cleaner

To replace the drum cleaner
1. Turn the printer off and disconnect the power cord.
2. Open the printer's top cover.
3. Locate and remove the gray plastic cover just in front the fuser
unit by lifting up on the arrow tabs.
4. Grasp both ends of the top of the drum cleaner, lift one end up
first, lift the other end up, and pull the drum cleaner straight up
and out of the printer.
5. Remove the new drum cleaner from its package, align the end
with the two gears to the left.
6. Align the smaller front gears on each end with the front slots in
the printer's drum cleaner area and align the larger left gear
with the back slot in the printer's drum cleaner area.
7. Lower the drum cleaner into the printer (it should slide easily
into the printer).
8. Press down on one end of the drum cleaner until it snaps into
place; then, press down the other end until it snaps into place.
9. Reinstall the gray plastic cover just in front the fuser unit with
the arrow tabs to the front with the arrows pointing to the back
of the printer.
10. Close the printer's top cover. Then, reconnect the power cord,
and turn on the printer.
9-22 Maintenance and Specificationsbb ________________________