Table of Contents
Advertisement
Warning:
Never use a power cord that is damaged. Check the
cord and plug monthly and replace immediately if you
find rust, tears, cracks, or other damage.
Turning the Printer On
Press the power switch in to turn (toggle) on the printer (fig. 2.31).
Power Switch
Fig. 2.31 Turn the Printer On
Printer initialization takes approximately 3 minutes. When READY/
IDLE displays, the printer is ready to accept print jobs.
Note:
Due to movement during shipping, XANTÉ recommends
calibrating your printer after setup. See "Accurate
Calibration Technology (X-ACT)" and "Colour Density
Calibration and Verification" in chapter 6.
Following initialization, a start-up page prints if that feature is
enabled. This page lists selected resolution, installed RAM, hard disk
identities, page count, enabled interfaces, and network information (if
Ethernet is used). Review this page for proper printer configuration. See
"Start-up Page" in chapter 6 for details.
Turning the Printer Off
To turn the printer off
1.
Verify that the READY/IDLE message displays.
2.
Press the power switch to turn (toggle) off the printer (fig. 2.31).
Note:
When printer is turned off, job information in memory is lost.
__________________________________________ Installation 2-27
Advertisement
Table of Contents
Troubleshooting
