Table of Contents
Advertisement
Caution:
Never touch the OPC belt's surface; only handle the
cartridge by its top handle. Leave the cartridge in its
protective package until installation. Touching the belt
and exposing it to bright light (over two minutes) may
cause permanent damage. If the belt is over exposed to
light, there is a chance you may be able to salvage it by
placing it in a dark room for several hours.
1.
Open the printer's front cover (fig. 2.7) if necessary. This pulls
the toner bays forward, making room for the OPC belt
cartridge behind the bays.
Caution:
If you do not open the front cover before the OPC
belt cartridge installation, permanent damage may
occur to the OPC belt cartridge.
2.
Open the printer's top cover by pulling the top cover latch
forward and lifting the cover up and back (fig. 2.13). Then, pivot
the OPC guides straight up, toward the front of the printer.
OPC
Guide
Front Cover
Fig. 2.13 Open the Top Cover and OPC Guides
3.
Remove the OPC belt cartridge from its package, pull the 2
tension pins straight out from each side, and remove the black
protective sheet (fig. 2.14).
2-12
Installationbb
_________________________________________
Guide
Top Cover
(Left)
Guide
(Right)
Advertisement
Table of Contents
Troubleshooting
