Xante ScreenWriter Colour ScreenWriter User Manual page 350

RESETTING JOB
ROLLER OPEN
STACKER FULL
TEST PRINT
TOP COVER OPEN
TRANSFER ROLLER COVER OPEN
W: BELT CART
W: FUSER
W: TRANS DRUM
11-12 Troubleshootingbb
The printer is resetting after the
Reset key has been pressed and
an active job has been
cancelled. (Status)
The transfer roller panel is open
in the lower feeder unit (LFU).
See "Replacing Transfer Roller"
in chapter 9. (Operator #18)
The output area on the top of the
printer is full and needs to be
emptied. (Operator #12)
The printer is printing a start-up
page. (Status)
The printer's top cover is open.
Close the cover. (Operator #18)
The back cover over the transfer
roller is open. Close the cover.
If it will not close, see
"Replacing the Transfer Roller"
in chapter 9. (Operator #18)
Check the OPC belt Cartridge. It
may need to be replaced. See
"Removing or Installing the OPC
Belt Cartridge" in chapter 2.
(Operator)
Check the fuser. It needs cleaning
or replacing. See "Replacing the
Fuser Unit" and "Interior
Cleaning" in chapter 9.
(Operator)
Check the transfer drum.
(Service)
____________________________________