Change The Ethertalk Zone Name; Using Xanté Command Center - Xante ScreenWriter Colour ScreenWriter User Manual

• Select the Phase 2 driver through the Network Control Panel under
Apple menu: Control Panels on a Macintosh with an older operating
system (System 6.X and earlier).
• Select Ethernet from the drop down menu in the AppleTalk
Control Panel under Apple menu: Control Panels on a Macintosh
with an operating system that supports Open Transport (System
7.5 and later and some versions between 6.X and 7.5).

Change the EtherTalk Zone Name

On an EtherTalk network with more than one zone, the network
router assigns your printer a default zone. Check with your System
Administrator to determine the correct zone for your printer; then, if
necessary, change the printer's zone name using XANTÉ Command
Center.
Using XANTÉ Command Center
1. Open XANTÉ Command Center by double-clicking its icon.
2. Choose Networking: AppleTalk: EtherTalk Zone Name. The
following window appears (fig. 5.1).
Fig. 5.1 EtherTalk Zone Name Window
3. Enter the new name for the EtherTalk zone (fig. 5.1).
Note: EtherTalk zone names are limited to 32 characters, are
not case sensitive, and cannot include the = (equal), ≅
(approximately equal), * (asterisk), : (colon), or @
(at) characters.
5-4 Ethernet Setup ________________________________________