Configure The Novell Server (Netware 3.X And 4.X) - Xante ScreenWriter Colour ScreenWriter User Manual

Note: Do not set passwords for access to the server unless
necessary. If a password has been set for a printer, it must be
reset to a null password before you can make changes to the
printer's Novell setup in XANTÉ Command Center. See
"Configure the Print Server Emulation" later in this chapter
to set the password.
To configure the Novell server for NetWare versions 3.X or 4.X see
the next section; for version 5.X, skip to "Configure the Novell
Server (NetWare 5.X)" later in this chapter.

Configure the Novell Server (NetWare 3.X and 4.X)

This section covers setup for Novell NetWare Version 3.X and 4.X
using PConsole.
1. Check the AUTOEXEC.NCF file on the Novell file server
from the server console. If the following statement is not in the
file, add it using a text editor.
Set allow unencrypted passwords = on
2. Login to the network with supervisory privileges.
3. Type PCONSOLE and press Enter.
4. Set up the print server name using the following procedure. To
use a print server name other than the default, see the previous
section.
Note: The print server name on the printer must match the
corresponding print server name on the Novell file
server. For example use xante_ps for both of these
names. It also is recommended that you name the
Novell file server queue a similar name such as
xante_q.
a. Select Available Options: Print Server Information
(version 3.X) or Available Options: Print Servers (for
version 4.X) and press Enter.
_______________________________________ Ethernet Setup 5-7