Using XANTÉ Command Center (PC)
Note: Your PC must be directly connected to the printer through a
bidirectional parallel or a straight-through serial cable to use
XANTÉ Command Center. You cannot set commands
through a network.
1.
Open XANTÉ Command Center by double-clicking its icon.
The following window appears (fig. 5.X).
Fig. 5.20 Command Center Window (PC)
2.
Choose Controller: General: TCP/IP Address. The following
window appears (fig. 5.21).
Fig. 5.21 TCP/IP Address Window (PC)
5-26 Ethernet Setup ________________________________________