Table of Contents
Advertisement
4.
Select LPR Port; then, click New Port to bring up the Add LPR
Compatible Printer window (fig. 5.26).
Note: If LPR is not an option, you must log in as the
Administrator and select Control Panel: Network:
Services and make sure that Microsoft TCP/IP Printing
is installed. If not, click Add and select this feature.
Then, restart your PC and LPR will appear as an
option for this procedure. (You may need the
Microsoft Windows NT CD to load this service.)
Fig. 5.26 Add LPR Compatible Printer Window
5.
Enter the printer's TCP/IP address in the field requesting the
name or address of the print server. Then enter the printer
name in the field below. Click OK.
6.
Select the General tab; then, click Print Test Page and check the
printer to see if the Windows NT Test Page printed correctly.
7.
Click OK. The Printer Properties window closes.
8.
Select File: Close. The Printers window closes.
After installing and configuring the AdobePS printer driver and PPD,
see "Configuring the Printer" in chapter 4 to verify that printer
interfaces are configured properly.
AppleTalk Setup for EtherTalk
After completing the AdobePS driver installation, use the following
procedure to configure your printer for Windows NT 4.X EtherTalk
printing.
5-30 Ethernet Setup ________________________________________
Advertisement
Table of Contents
Troubleshooting
