Table of Contents
Advertisement
Note:
Even though 300 dpi is selected in the application, the
document prints at the resolution set on the printer.
6.
Select Yes to answer the question. Then, the question, "Do you
wish to append a ^Z?" appears.
7.
Select NO. The question "Is your PostScript device connected
to a <S>erial or <P>arallel port?" appears.
8.
Select the port the printer is connected to, serial or parallel.
9.
Enter the address of the port you selected or press the Enter
key if there is no change.
10.
Check over your device location, and if you are satisfied, press
the Enter key for no changes. The question "Do you want to
change anything?" appears.
11.
Check over the list for all selections. To make changes, type
YES and press the Enter key; then make the desired changes.
Otherwise, type NO, press the Enter key. The message "Enter
a description for the plotter:" appears.
12.
Enter the name you would like for the printer to have (such as
XCSW).
13.
Select Configure: Exit.
AutoCAD is now configured to print to your printer.
Printing from AutoCAD 12
After you configure AutoCAD to print to your printer, use the
following procedure to print from AutoCAD.
1. Open your AutoCAD program.
______________________ Application Notes and Page Design A-11
Advertisement
Table of Contents
Troubleshooting
