Table of Contents
Advertisement
5.
Reinstall the transfer drum cleaner (fig. 9.8).
6.
Insert the 16" x 3.25" (406 mm x 83 mm) rectangle piece of
packing foam over the drum cleaner (fig. 9.8).
7.
Reinstall the drum cleaner cover (fig. 9.8) and tape it down
using transparent tape.
Remove the Oil Bottle and Cleaning Roller
Caution:
The oil bottle and any stray oil must be removed from
the printer to prevent printer damage during shipping.
Such damage is not covered under the printer warranty.
Warning!
The fuser unit becomes extremely hot when the printer
is in use. After the printer is turned off, wait 20
minutes for the fuser unit to cool before handling it.
1.
Open the 2 oil bottle locks by turning them out toward the
sides (fig. 9.9).
Cleaning Roller Locks
Oil Bottle Locks
Front of Printer
Fig. 9.9 Open the Oil Bottle Locks
2.
Remove the oil bottle using the following procedure (fig.
9.10).
a.
Slide a clean sheet of paper under the oil bottle as you
pull it up and out to prevent a spill. Then, place the
bottle in an oil proof plastic bag and seal the bag.
9-12 Maintenance and
Fig. 9.10 Remove the Oil Bottle
Specificationsbb
________________________
Oil Bottle
Advertisement
Table of Contents
Troubleshooting
