Job Timeout; Language - Xante ScreenWriter Colour ScreenWriter User Manual

•
Test key moves to the next number to the left of the current
number flashing.
•
Enter key accepts new address (if valid) and returns to I/F:IP
Address menu. The menu will display a message if the address
entered is invalid.
Note: You must turn the printer off and restart it for the new IP
address to take effect. To change the subnet mask or default
gateway address, use XANTÉ Command Center (Macintosh)
or contact XANTÉ Technical Support for PC configuration
files.

Job Timeout

Job Timeout allows you to select the number of seconds the printer
waits for additional data before cancelling a job and returning to the
READY/IDLE state.
Set Job Timeout from the UTILITY: JOB TIMEOUT configuration
menu. The factory default of 40 seconds (40 Sec) is an average
setting. Set timeout according to the type of files you send. Use a low
setting for small, simple files to prevent an indefinite tie-up on one
job. Use the 300 or Never setting for large files, such as graphic
intensive or CAD (Computer Aided Design) files, to allow enough
time for processing. With the NEVER selection the printer does not
timeout; it waits until it receives additional data or until the printer is
reset.

Language

Language options allow you to select the language for the printer's
front panel window. Set the display language from the UTILITY:
LANGUAGE configuration menu. English is the factory default;
other options are Spanish (Espanol), French (Francais), German
(Deutsch), and Japanese.
_______________________________________ Configuration 6-27