Verifying the Serial Setup
To verify your serial setup
1.
Turn on your printer and PC.
2.
Verify that the PC and printer communication settings match.
•
Check your PC documentation to determine how to check
and set the PC settings.
•
Check and set your printer settings using the front panel
configuration menus. See "Interface Control" in chapter 6.
3.
Verify that the printer's serial interface is enabled and
configured properly. See "Interface Control" in chapter 6.
Before using your printer, install and configure the Adobe PostScript
printer driver and your printer's PPD. See "XANTÉ Utilities
Installer" and "Adobe PostScript Printer Drivers" in chapter 4.
Colour Density Calibration
After installing, moving, or storing the printer for extended periods
or after installing new toner cartridges, you should verify that your
printer's colour density is calibrated. See "Color Density Calibration
and Verification" in chapter 8 for details.
__________________________________________ Installation 2-29
◊◊◊