Trademarks ® XANTÉ is a registered trademark of XANTÉ CORPORATION. Adobe®; Adobe® PageMaker®; Adobe® PostScript®, the PostScript®, and Adobe® logos are registered trademarks of Adobe Systems Incorporated. Adobe® Acrobat™ is a trademark of Adobe Systems Incorporated which may be registered in certain jurisdictions.
Installation-Macintosh... 23 Installing the PostScript Driver ... 24 Installation-Macintosh OS X ... 25 OS X (version 10.1.5) ... 26 Mac OS X Printer Configuration ... 27 Page Setup ... 27 Printer Features ... 27 OS X (version 10.2.1) ... 28 Mac OS X Printer Configuration ...
Getting Set-up Removing the Printer following items: Note: Fig. 1 Removing the Printer. WARNING: Always have two people lift the printer using the recessed grips on the printer’s sides. Your printer package contains the Installing Toner Cartridge • Your XANTÉ printer •...
Fig. 6 Insert Pins into Guide Channels. Note: If tape is not fully removed, it may reduce print quality and cause printer damage. Fig. 7 Insert Toner Cartridge. Fig. 8 Close Top Cover. Fig. 9 Close Multipurpose Feeder. Standard Cassette...
Getting Set-up (continued) Fig. 11 Remove Cassette from Printer. Fig. 13 Adjust Length Guide. Fig. 12 Remove Cassette Cover. Fig. 14 Adjust Width Guide. Fig. 15 Load Paper. Note: To prevent paper jams, make sure the paper fits between the paper guides and under the cassette’s...
3.94” x 5.83” (100 mm x 148 mm) to 13” x 18.5” (330 mm x 902 mm). With the FilmMaker 4, you can feed media up to 13” x 35.5” (330 mm x 902 mm) and can handle media weights from 16 - 36 lb (60 - 155 g/m Fig.
Fig. 21 Connect Power Cord to Printer. Fig. 23 Printer Ports. Fig. 22 Turn Printer On. Parallel Port (PC) The FilmMaker 4 series printers have 36-pin Connector To Printer Fig. 24 Parallel Cable. Plug the cable’s 36-pin connector into...
Connecting to Printer Ports (continued) Connect one end of the CAT 5 Ethernet Note: cable to your printer’s Ethernet port (fig. 25). Connect the cable’s other end to the appropriate port on your network. *USB does not support Window 98 or Me.
Network: IpAddr menu. The menu will display a message if the entered address is invalid. You must turn the printer off and restart it for the new IP address to take effect. Fig. 38 Select Software Utilities.
After you click Finish (fig. 44), a ReadMe file window appears. Read it carefully and then close the window. The Restart Computer window appears (fig. 45). Fig. 45 Restart Your Computer. Click Finish. Printer Driver Installation Fig. 46 Click Install Printer.
Page 13
Fig. 50 Read File Destination. Click Yes. Fig. 51 Choose Language. Click OK. Note: After clicking OK, Windows launches the Adobe® PostScript® Printer Driver setup program. This may take a few moments. Fig. 52 Read Adobe Window. Click Next. Fig. 53 License Agreement. Click Accept.
Go to DOS (Command) Prompt to ping the printer. c:\ping (IP Address) Note: If you can ping the printer, go on to step 10. If you cannot ping your printer, contact your Network Administrator. 10. Go to your Printer Properties (fig. 69) and...
Fig. 71 Highlight XanteLPR; click OK. then, click OK. Fig. 72 Enter IP Address and Queue Name. 13. Enter your printer’s IP address and Queue name; then, click OK (fig. 72). 14. Click Apply when the Printer Properties window reappears; then, click OK.
Network: IpAddr menu. The menu will display a message if the entered address is invalid. You must turn the printer off and restart it for the new IP address to take effect. Fig. 74 Click Install Printer.
Fig. 86 Print Test Page. Click Next. Fig. 87 Setup Complete. Click Finish. Network Setup Select Start: Settings: Printers and Faxes. Highlight your printer and click the right mouse button. Select Properties from the drop-down menu. Click the Ports tab (fig. 88).
Page 21
Next. Fig. 93 Click Finish. Close Window. Fig. 91 Enter IP Address. Click Next. Fig. 94 Go back to Printer Properties. Select the Ports tab, highlight your printer’s port and click Configure Port. Fig. 95 Select LPR Byte Counting Enabled...
Subnet, and Gateway addresses. Go to DOS (Command) Prompt to ping the printer. c:\ping (IP Address) If you can ping the printer, go on to step 10. If you cannot ping your Fig. 96 Printer Properties Window. printer, contact your Network Administrator.
PPD Configuration Fig. 98 Highlight Standard TCP/IP Port, click New Port. 13. Follow the on-screen directions. Then, enter your printer’s name or IP address when prompted. 14. Click Finish when complete. Then close all remaining windows. Fig. 99 Device Settings Window Select Installed for each option your printer may have;...
Note: If AdobePS doesn’t open, simply appropriate application(s); click double-click AdobePS Installer in the Printer Drivers: AdobePS 8.7.3: (appropriate language) folder on the Installing the PostScript Driver You can install the Adobe PostScript Driver (Adobe PS) in two ways from the XANTÉ...
Page 25
This section takes you through the installation process on a Macintosh OS X operating system. You must have the latest OS X version to properly install this printer. Note: You must first verify that AppleTalk After registering your printer, you...
Macintosh-OS X Installation (continued) Active, and click Apply Now. Then, close the window. Fig. 113 Click Install FilmMaker 4. Fig. 112 Network Window OS X (version 10.1.5) Note: You must double-click the OSX_setup icon The installation window does not open automati- Fig.
FilmMaker 4_OSX: readme.rtf. Fig. 118 Page Setup Window Read the ReadMe file; then, click close or Select Format For: FilmMaker 4 in the select File and go to Page Setup. Page Attributes window (fig. 119). Click OK once you have selected the desired paper size, orientation, and scale Select File from the top menu bar;...
Macintosh-OS X Installation (continued) Fig. 122 Click Install FilmMaker 4. Fig. 121 Select Appropriate Features; click Print. OS X (version 10.2.1) Note: You must double-click the OSX_setup icon The installation window does not open automati- cally. Fig. 123 Click Add Printer.
8393 (US and Canada). You can configure your printer by Fig. 128 Page Setup Window Select Format For: FilmMaker 4 in the Page Attributes window (fig. 129). Click OK once you have selected the desired paper size, orientation, and scale...
Internet Printer Status (continued) Fig. 129 Page Attributes Window Printer Features Fig. 131 Select Appropriate Features; click Print. Fig. 130 Select File: Print; click Printer Features. Internet Printer Status Once your printer has been installed onto your system, you can check its status,...
This link allows you to print a Start-up Page, Low Toner Page, Network Page, Font List Page, Font Sample Page, and Menu Layout Page. For more information about the FilmMaker 4 or other XANTÉ printers, • Tech Support please log onto our website: 1-800-926-8393 (US and Canada) www.xante.com/help...