Colour Density Calibration And Verification - Xante ScreenWriter Colour ScreenWriter User Manual

c. Press the Menu key until the amount which would most
closely adjust the line to the desired length appears.
Then, press the Enter key. For example, if Line A is
250.46 mm instead of 251.46 mm, select 1.00 mm to add
one mm to make the line the correct length.
6. Measure Line B. Use the following procedures to adjust the
printer for the correct line length.
a. Note the amount Line B is over or under 388.61 mms.
b. Press the Menu key until LINE B appears. Then, press
the Enter key.
c. Press the Menu key until the amount which would most
closely adjust the line to the desired length appears.
Then, press the Enter key. For example, if Line B is 389
mm instead of 388.61 mm as it should be, select -0.50
mm to shorten the line to 388.50.
7. Press the Reset key to return to the previous menu level. Then,
press the Menu key until XACT: TEST PAGE reappears and
press the Enter key to print a new test page.
8. Repeat steps 5 and 6 until the line measurements agree with
the lengths listed on the test page.
9. Press the On Line key when the line lengths are correct.
READY/IDLE appears in the window.
Now the printer's line lengths are calibrated within 1/2 mm.

Colour Density Calibration and Verification

The UTILITY: UTILITY PAGES menu includes two color control
options, Target Calibrate and Target Verify. Your printer needs to be
calibrated using the printer front panel Target Calibrate option during
the installation process.
_______________________________________ Configuration 6-17