Table of Contents
Advertisement
The printer has power but no start-up page prints.
•
Make sure the start-up page feature is enabled. See
"Start-up Page" in chapter 6.
•
Check the front panel window for a status message. See
"Status Messages" in this chapter.
•
Make sure toner cartridges are installed properly. See
"Toner Cartridges" in chapter 2.
•
Make sure media is in the selected tray and the tray is
properly installed. See "Paper Cassette" in chapter 2.
•
Make sure that the printer has had enough time to print the
start-up page. Warming up from a cold startup can take up
to 3 minutes before the page prints.
My printer does not respond properly to my Macintosh using a
LocalTalk connection.
•
Make sure all cables are connected and seated properly.
See "Connecting to the LocalTalk Port" in chapter 2.
•
Make sure both ends of the LocalTalk network have
terminating resistors installed. See "Connecting to the
LocalTalk Port" in chapter 2.
•
Make sure the Macintosh is set up for LocalTalk. See
"Connecting to the LocalTalk Port" in chapter 2.
•
Make sure the correct Adobe PostScript printer driver and
your printer's PPD are installed and configured properly.
See "Adobe PostScript Printer Drivers" in chapter 3.
•
Make sure the correct Adobe PostScript printer driver and
your printer are selected in the Chooser. See "Adobe
PostScript Printer Drivers" in chapter 3.
•
Make sure the AppleTalk button is active in the Chooser.
•
Make sure the LocalTalk port is enabled on the printer.
See "Interface Control" in chapter 6.
•
Make sure the printer is on line. See "Interface Control" in
chapter 6.
11-14
Troubleshootingbb
____________________________________
Advertisement
Table of Contents
Troubleshooting
