Table of Contents
Advertisement
Configure the Novell Print Server Interface
Use XANTÉ Command Center and printer front panel menus to enable
the Novell Print Server interface on your printer and to configure the
timeout and frame type options for your network environment.
•
To enable the Ethernet interface, which directs the printer to
login to the listed file servers and begin printing jobs from the
assigned print queues, use either Command Center or printer
front panel menus.
•
To configure the frame type used on your network, use either
XANTÉ Command Center's Macintosh version or printer front
panel menus.
•
To configure the Novell timeout, which specifies the number of
minutes that the printer waits before disabling the Novell print
server emulation when an assigned file server cannot be found,
use printer front panel menus.
This section describes Ethernet interface configuration using
XANTÉ Command Center. See chapter 6 to use front panel menus.
See chapter 3 (Macintosh) or 4 (PC) to install and configure
Command Center on your host computer.
Using XANTÉ Command Center (PC)
1.
Open XANTÉ Command Center by double-clicking its icon.
2.
Choose Controller: Novell: Printing: Login to File Servers.
Click OK in the message box to direct the printer to login to
the assigned file servers.
3.
Choose Controller: Novell: Printing: Enable Printing. Click
OK in the message box to direct the printer to begin printing
jobs from the assigned print queues.
4.
Choose File: Exit. Command Center closes.
Using XANTÉ Command Center (Macintosh)
1.
Open XANTÉ Command Center by double-clicking its icon.
5-20 Ethernet Setup ________________________________________
Advertisement
Table of Contents
Troubleshooting
