Table of Contents
Advertisement
2.
Select Utility: Utility Pages: Target Calibrate from the
printer's front panel. The Colour Density Calibration Page
prints (fig. 6.12).
3.
Place the calibration page in a well lit area at a distance of
approximately 30" (762 mm) and compare colors on the
calibration page to the Calibration Target (fig. 6.13) provided
with your printer.
a.
Align the target's black cutout over the top black patch
in the black column on the calibration page.
b.
Slide the target down the column and determine which
patch most closely matches the black on the target.
c.
Mark the selected patch through the target's cutout, or
make a note of the patch number.
d.
Repeat steps 3a through 3c for cyan, magenta, and
yellow.
4.
Select Utility: Laser Power: Black Adjust from the printer's
front panel.
5.
Use the arrow keys to locate the appropriate patch number, and
then press Enter to select that number.
_______________________________________
Fig. 6.13 Calibration Target
Configuration 6-19
Advertisement
Table of Contents
Troubleshooting
