Table of Contents
Advertisement
10.
Reconnect all interface cables and the power cord. Then, turn
on the printer; when READY/IDLE appears, the printer is
ready to accept a job.
Removing the Duplexer
To remove the duplexer
1.
Turn off the printer, disconnect the power cord from the power
source, disconnect any interface cables, and remove any media
from the top of the printer.
2.
Remove the LFU left side cover and unplug the duplexer cable
(figs. 10.15 and 10.16).
3.
Open the duplexer's top cover and loosen the two duplexer
thumb screws (fig. 10.14).
4.
Pull the duplexer back, rotating the upper part first to free its
top tabs from the printer slots; then, ease back until the fixing
pins are free from the LFU slots (fig. 10.13).
5.
Replace the LFU caps by sliding them straight back into the
LFU (fig. 10.12).
6.
Replace the printer's two upper caps by inserting their bottom
tabs into the slots on the printer and then rotating the caps up
until their top tabs snap into place (fig. 10.12).
7.
Replace the media exit cover by inserting its bottom hooks into
the slots on the printer and then rotating the cover up until the
top tabs snap into their corresponding slots on the printer (fig.
10.12).
8.
Reconnect all printer interface cables and the power cord.
Then, turn on the printer; when READY/IDLE appears, the
printer is ready to accept a job.
9.
Repack the duplexer in its original packing and store it in a
location that meets the same guidelines as in "Storing the
Printer" in chapter 9.
___________________________________________
Options 10-17
Advertisement
Table of Contents
Troubleshooting
