Horizontal banding appears on my output.
Horizontal white banding causing part of the image to disappear.
1
Toner stains appear on my output.
_____________________________________ Troubleshooting 11-23
•
Vibration can damage the OPC belt
cartridge causing the belt to rotate unevenly.
Replace the cartridge. See "Removing or
Installing an OPC Belt Cartridge" in chapter
2.
•
Make sure that the transfer unit is properly
installed and the transfer roller lock lever is
closed (fig. 9.3).
•
The transfer unit may be damaged. Replace
it. For transfer unit replacement, contact
XANTÉ; see "Technical Support" at the end
of this chapter.
•
Toner stains are usually due to loose toner
inside the printer. Clean it. See "Cleaning
the Printer" in chapter 9.
•
Check the toner waste pack for damage and
replace it if necessary. See "Replacing the
Toner Waste Pack" in chapter 9.
•
One of the toner cartridges may have debris
on its developer roller. Remove the cartridge
and clean its roller surface by gently wiping
it off with a dry, lint-free cotton cloth. Use
the white gear on the end of the cartridge to
rotate the roller to reach all sides.
•
Check the toner cartridge(s) for damage and
replace if necessary. See Removing and
Installing a Toner Cartridge" in chapter 2.