Table of Contents
Advertisement
•
Make sure the printer's location meets the requirements in
"Printer Location" in chapter 2.
•
Never oil the printer.
•
Always allow the printer back vent at least an 8.0" (200 mm)
clearance to prevent overheating. Never insert anything into the
vent.
•
Make sure the output tray does not overfill. Overfilling can block
media as it comes out and cause a printer jam.
•
Check the power cord and plug monthly and replace
immediately if you find damage.
•
Never use any solvent for cleaning the printer (interior or exterior).
Storing the Printer
Caution:
Always remove the fuser unit and oil bottle before
moving, transporting, or storing the printer for extended
periods to prevent an oil spill. Such damage is not
covered under the printer warranty.
Use the following procedure when storing the printer for an extended
period.
1.
Turn off the printer. Unplug the power cord from the power
source.
2.
Remove all media from the top of the printer; remove the toner
cartridges, OPC belt cartridge, fuser unit. Close any open
covers (top, front, or back). See chapter 2 for instructions.
Caution:
3.
Store the printer, toner cartridges, OPC belt cartridge, fuser
unit, oil bottle, and media properly.
9-4 Maintenance and
Cover the OPC belt cartridge immediately with
paper to protect the belt from damage caused by
light exposure.
Specificationsbb
________________________
Advertisement
Table of Contents
Troubleshooting
