Table of Contents
Advertisement
3.
Select the TCP/IP address class (fig. 5.21). Then, set the
network node IDs using the arrows below the numbers to
change them; set the last digit of the Subnet Mask (fig. 5.21)
using the arrows to the right.
Note: Mask values which can be changed are dependent on
the selected class.
4.
Set the Gateway address as desired; then, click OK (fig. 5.21).
Note: The Allow Gateway Addressing option must be
selected for you to be able to change Gateway address
values; if it is not selected, you cannot change the
values.
5.
Select File: Exit. Command Center closes.
6.
Restart the printer to make the new TCP/IP address take effect.
Using XANTÉ Command Center (Macintosh)
1.
Open XANTÉ Command Center by double-clicking its icon.
The following window appears (fig. 5.22).
Fig. 5.22 Command Center Window (Macintosh)
2.
Choose Networking: TCP/IP: Address. The following window
appears (fig. 5.23).
Fig. 5.23 TCP/IP Address Control Window (Macintosh)
_______________________________________ Ethernet Setup 5-27
Advertisement
Table of Contents
Troubleshooting
