Configure The Print Server Emulation - Xante ScreenWriter 3 Manual

a.
b.
c.
d.
e.
The Novell server is now configured for NetWare version 5.X.

Configure the Print Server Emulation

Following the file server setup, the Novell System Administrator
assigns the printer a list of file servers to poll and gives it the login
name and password (if required) to access each server. This section
describes configuring the print server emulation using XANTÉ
Command Center. See your Novell NetWare documentation to use
that application. See chapter 3 (Macintosh) or 4 (PC) to install and
configure XANTÉ Command Center on your host computer.
Using XANTÉ Command Center (PC)
Note: Your PC must be directly connected to the printer through a
parallel or serial cable to use XANTÉ Command Center.
You cannot set the commands through a network.
1. Open XANTÉ Command Center by double-clicking its icon.
2. Choose Controller: Novell: Add File Server.
_______________________________________
Press the Online key once to take the printer offline.
Press the Menu key until SETUP:I/F appears; then, press
the Enter key.
Press the Menu key until I/F:NVL PSRV appears; then
press the Enter key. NVL PSRV:ENABLE appears.
Press the Enter key. Then, press the Menu key until
ENABLE:yes appears.
Press the Enter key. Then press the Online key.
Fig. 5.13 Add File Server Window
Ethernet Setup 5-15