Table of Contents
Advertisement
19
Check the Printer Settings
Power Save Mode
The printer is set at the factory to enter the Power Save
mode after 1 hour. You can change this setting to 5, 15,
30 or 240 minutes.
To change the interval:
Press MENU repeatedly until
appears on the display.
MENU
Press ITEM + repeatedly until
appears on the display.
TIME
Press VALUE (+ or -) repeatedly until the desired
setting appears on the second line of the display.
Press SELECT.
An Asterisk (*) appears next to the new setting.
Press ON LINE to save the setting and exit the menu.
SYSTEM CONFIG
POWER SAVE DELAY
Duplex Mode
!
If you experience curling when printing a file in
duplex mode, switch to 28-lb. US Bond paper.
If your printer is equipped with a duplex unit and you
want duplex printing to be the printer default:
Press MENU repeatedly until
on the display.
Press ITEM + repeatedly until
the display.
Press VALUE +.
ON will appear on the second line of the display.
Press SELECT.
An Asterisk (*) appears next ON.
Press ON LINE to save the setting and exit the menu.
Printer Emulation
The printer is set at the factory to automatically detect the
emulation of an incoming print job. To change it to
always be PCL or Adobe PostScript, see "Setting the
Emulation" under Control Panel, Walk-up Functions in
the on-line XANTÉ ColourLaser 21 Series User's Guide.
Display Language
If you wish to choose a display language other than
English, see "Setting the Control Panel Display
Language" under Control Panel, Walk-up Functions in
the on-line XANTÉ ColourLaser 21 Series User's Guide.
appears
PRINT MENU
appears on
DUPLEX
27
Advertisement
Table of Contents
