Discovery Protocols Command Set
Enterasys Discovery Protocol
3.2.2.5
set cdp hold-time
Use this command to set the hold time value for CDP discovery protocol configuration messages.
set cdp hold-time hold-time
Syntax Description
hold-time
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set CDP hold time to 60 seconds:
Matrix(rw)->set cdp hold-time 60
3-10 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the hold time value for CDP messages in
seconds.Valid values are from 15 to 600.