Enterasys Matrix 2G4072-52 Configuration Manual page 250

Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
vid vlan-id | dot1p
cos cos-value
dscp dscp-value
port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Usage
As described in the ANSI/TIA Standards document 1057, the Network Policy TLV is "intended for
use with applications that have specific real-time network policy requirements, such as interactive
voice and/or video services" and should be implemented only on direct links between network
connectivity devices and endpoint devices. Refer to the ANSI/TIA Standards document 1057 for
descriptions of the application types.
After you configure Network Policy TLVs, you must also configure the port to send the Network
Policy TLV with the
3-54 Matrix DFE-Platinum and Diamond Series Configuration Guide
set lldp port tx-tlv command.
(Optional) VLAN identifier for the port. The value of
vlan-id can range from 1 to 4094.
Use dot1p if the device is using priority tagged frames,
meaning that only the IEEE 802.1D priority level is
significant and the default PVID of the ingress port is
used.
(Optional) Specifies the Layer 2 priority to be used for
the application being configured. The value can range
from 0 to 7. A value of 0 represents use of the default
priority as defined in IEEE 802.1D.
(Optional) Specifies the DSCP value to be used to
provide Diffserv node behavior for the application being
configured. The value can range from 0 to 63. A value
of 0 represents use of the default DSCP value as defined
in RFC 2475.
Specifies the port or range of ports to be affected.