Set Lldp Port Trap - Enterasys Matrix 2G4072-52 Configuration Manual

3.2.4.14

set lldp port trap

Use this command to enable or disable sending LLDP notifications (traps) when a remote system
change is detected.
set lldp port trap {enable | disable} port-string
Syntax Description
enable
disable
port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example enables transmitting LLDP traps on ports ge.1.1 through ge.1.6.
Matrix(rw)->set lldp port trap enable ge.1.1-6
Enable transmitting LLDP traps on the specified ports.
Disable transmitting LLDP traps on the specified ports.
Specifies the port or range of ports to be affected.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
3-47