Configuration Tasks - Enterasys Matrix 2G4072-52 Configuration Manual

Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
The standard specifies that certain TLVs are mandatory in transmitted LLDPDUs, while others are
optional. You can configure on a port-specific basis which optional LLDP and LLDP-MED TLVs
should be sent in LLDPDUs.

Configuration Tasks

The commands included in this implementation allow you to perform the following configuration
tasks:
Step Task
1. Configure global system LLDP parameters
2. Enable/disable specific ports to:
•
Transmit and process received LLDPDUs
•
Send LLDP traps
•
Send LLDP-MED traps
3. Configure an ECS ELIN value for specific ports
4. Configure Network Policy TLVs for specific ports
5. Configure which optional TLVs should be sent by
specific ports. For example, if you configured an
ECS ELIN and/or Network Policy TLVs, you
must enable those optional TLVs to be
transmitted on the specific ports.
Commands
The commands to review and configure LLDP and LLDP-MED are listed below and described in
the associated section as shown.
•
show lldp (Section
•
show lldp port status
•
show lldp port trap
•
show lldp port tx-tlv
•
show lldp port location-info
3-26 Matrix DFE-Platinum and Diamond Series Configuration Guide
3.2.4.1)
(Section 3.2.4.2)
(Section 3.2.4.3)
(Section 3.2.4.4)
(Section 3.2.4.5)
Command(s)
set lldp tx-interval
set lldp hold-multiplier
set lldp trap-interval
set lldp med-fast-repeat
clear lldp
set/clear lldp port status
set/clear lldp port trap
set/clear lldp port med-trap
set/clear lldp port location-info
set/clear lldp port network-policy
set/clear lldp tx-tlv