Cisco Discovery Protocol - Enterasys Matrix 2G4072-52 Configuration Manual

Discovery Protocols Command Set

Cisco Discovery Protocol

3.2.3 Cisco Discovery Protocol
Purpose
To enable and configure the Cisco Discovery Protocol, used to discover network topology. When
enabled, the Cisco Discovery Protocol allows Cisco devices to send periodic PDUs about
themselves to neighboring devices. The Cisco Discovery Protocol is also used to manage the Cisco
module of the Convergence End Points (CEP) IP phone detection function described in
Section 14.3.8.
Commands
The commands used to review and configure the Cisco Discovery Protocol are listed below and
described in the associated section as shown.
•
show ciscodp (Section
•
show ciscodp port info
•
set ciscodp status
•
set ciscodp timer
•
set ciscodp holdtimer
•
set ciscodp port
•
clear ciscodp (Section
3-12 Matrix DFE-Platinum and Diamond Series Configuration Guide
3.2.3.1)
(Section 3.2.3.2)
(Section 3.2.3.3)
(Section 3.2.3.4)
(Section 3.2.3.5)
(Section 3.2.3.6)
3.2.3.7)