Enterasys Matrix 2G4072-52 Configuration Manual page 187

Table 2-9 Enabling the Switch for Routing
To do this task...
Step 1 Configure a routing
module.
Step 2
Enable router mode.
Step 3
Enable router
Privileged EXEC
mode.
Step 4 Enable global router
configuration mode.
Step 5 Enable interface
configuration mode
using the interface of
the routing module.
Step 6
Assign an IP address
to the routing
interface.
Step 7
Enable the interface
for IP routing.
The example in Figure 2-8
•
Configure module 1 as a routing module.
•
Configure VLAN 1 on IP address 182.127.63.1 255.255.255.0 as the routing interface for that
module.
Type this
command...
set router module
router module
enable
configure
terminal
interface {vlan
vlan-id | loopback
loopback-id
ip address
{ip-address
ip-mask}
no shutdown
shows how to:
Matrix DFE-Platinum and Diamond Series Configuration Guide
Preparing the Device for Router Mode
Pre-Routing Configuration Tasks
At this prompt...
Switch:
Matrix (rw)->
Switch:
Matrix (rw)->
Router:
Matrix>Router1>
Router:
Matrix>Router1#
Router:
Matrix>
Router1(config)#
Router:
Matrix>Router1
(config-if (Vlan 1 |
Lpbk 1))#
Router:
Matrix>Router
(config-if (Vlan 1 |
Lpbk 1))#
For details,
see...
Section 2.3.2.2
Section 2.3.2.4
Section 2.3.3
Section 2.3.3
Section 12.2.1.2
Section 12.2.1.5
Section 12.2.1.6
2-161