Enterasys Matrix 2G4072-52 Configuration Manual page 217

Syntax Description
status
vvid
trust-ext
cos-ext value
port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Set the CiscoDP port operational status
disable Do not transmit or process CiscoDP PDUs
enable Transmit and process CiscoDP PDUs
Set the port voice VLAN for CiscoDP PDU transmission
<vlan-id> Specify the VLAN ID, range 1-4094.
none No voice VLAN will be used in CiscoDP PDUs
dot1p Instruct attached phone to send 802.1p tagged frames
untagged Instruct attached phone to send untagged frames
Set the extended trust mode on the port.
trusted Instruct attached phone to allow the device connected to it
to transmit traffic containing any CoS or Layer 2 802.1p
marking. This is the default value.
untrusted Instruct attached phone to overwrite the 802.1p tag of
traffic transmitted by the device connected to it to 0, by
default, or to the value configured with the cos-ext
parameter.
Instruct attached phone to overwrite the 802.1p tag of
traffic transmitted by the device connected to it with the
specified value, when the trust mode of the port is set to
untrusted. Value can range from 0 to 7, with 0 indicating
the lowest priority.
Specifies the port(s) on which status will be set. For a
detailed description of possible port-string values, refer to
Section
Matrix DFE-Platinum and Diamond Series Configuration Guide
4.1.1.
Discovery Protocols Command Set
Cisco Discovery Protocol
3-21